Pallet Rack Articles, Resources

Pallet Rack Guide - 655.42 KB

BLOG: Pallet rack

Pallet rack specification drawings

How beam loading affects pallet rack capacities

Fire codes and pallet rack: how to comply

Pallet Rack is Cost-Effective Storage

Pallet Rack Style Guide

The Fishbone Layout - Could it Work for You?

How drive-in & drive through achieve storage density

Configuring Pallet Rack

Calculating Overall Capacity

Color Options

Options & Accessories

Installation Guide

Operations & maintenance

Seismic Zone Considerations

Pick module design

Seismic Considerations for Racks Located in Public Areas

Pallet rack beam capacities can be affected by loading patterns

When loads aren't evenly distributed, capacities decline

Most pallet rack beam capacities are based upon "evenly distributed loads". This refers to the front-to-back direction as well as horizontally along the beam width. But what does that really mean?

Looking at it from a side view, as shown below, the load rests across the top surface of the beam, and the full height of the beam absorbs the load weight.

Figure 1: Evenly distributed loads utilize the full height of the beam for higher capacities

When loads are not evenly distributed, beam capacities are less than as shown in our published capacity listings.

For instance, when loads are concentrated between beams, as shown below, the load is applied only to that portion of the beam that is below the step ledge. In the case of a 3-inch (high) beam, the load would be applied to less than one half of the steel in the beam. Obviously, capacities will fall in this scenario.

Figure 2: loads inside the beams utilize the step for capacity purposes. This means a lower beam capacity

Loading as shown in above results in the load being applied to the beam in an "off center" fashion. With the load applied only to the "step Ledge", a "twisting" force is applied to the beam. This force can cause the beams to spread, as well as possibly causing the beam to tear out of the keyholes in the columns.

For any projects involving non-standard loading patterns, please contact us for design assistance. This isn't to say that you cannot load directly onto rack decking, especially if that decking is sufficient to handle the load, but you should use caution on very heavy loads. Ask us for help if you aren't sure.