24" x 72" optional split hinged bridge required for this type of installation. (12"x72" is standard)
Wide flange beam by others
Rubber dock bumpers by others
Black and yellow safety striping
Chrome plated rams
Predrilled base frame for lagging lift to floor
48" long hydraulic connecting hose with 1/2" connector at base frame. Included with lift. Other sizes available contact us for pricing.
Connector
Mid-rail
Kickplate
Bevel toe guards four sides
Up-Down push button station NEMA 1, 3, 3R, 4, 4X with 20ft control cord
Incoming power source
Motor controller in NEMA 12 enclosure
To motor on power unit
To down solenoid on power unit
Power unit 5 hp 230V 60Hz 3Ph motor mounted on reservoir 26"w x 22"l x 21"h (including motor) with brackets for wall mounting.
Run 3" conduit from power unit location to lift base - by others
Installer to run 1/2" hydraulic 2-wire hose through 3" conduit from power unit to connecting hose.
Important Notes:
Pit mounted lifts will require connection to your electric service. The lift must be installed on a concrete pad. You may also need a building permit to install these lifts. Check your local building codes.
Electricians, building permits, concrete work, and installation are the responsibility of the purchaser.