With a reflective brilliance of up to 1000 candle power, each dock reflector provides plenty of illumination in dark loading dock approaches and aids drivers in positioning the trailer accurately when mounted correctly. The reflective material that makes these so powerful is an advanced retro-reflective microprismatic material with superior weatherability in cold, heat and wet conditions. Exceeding clause 7.5 of the industry standard EN471, this product is reflective at even wide angles and at distances typical for loading dock approaches. RF weld sealed to reinforced vinyl backing, each reflector has a brass grommet at each corner for mounting with a wall anchor tool or concrete screw anchors. Unit requires no light bulbs or electricity to operate. Color: Yellow
When ordering, consider alternating colors if purchasing for several loading docks. Doing this will further aid drivers when they can see that the dock they are pulling into has yellow reflectors, whereas the docks on each side are marked with white or red/white reflectors.
Mounting instructions
Utilize a wall anchoring tool to "shoot" anchors into dock sidewall using holes in corners of reflector as anchor points.
Lacking a concrete anchor tool, use 1" plastic screw anchors with screws, drill with 1/4" drill bit, scribe, ruler, level, and screw driver.
The reflectors should be vertically mounted approximately 2" below the rubber bumpers, but should be adjusted to avoid contact with the drive.
Drill one of the top holes first and mount in place. Leave this screw loose so as to allow vertical and plumb adjustments prior to tightening. Drill the remaining holes, then tighten all screws.