Your shopping cart is currently empty.
Speed Bump End Cap (single) - 9"L x 12"W x 2-1/4"H, Black, Recycled Rubber
Help slow traffic 1-5 mph in and around your facility
SKU: PG-ENC-26999
Manufacturer: Post Guard
Finish off the ends of your speed bump with these 100% recycled rubber end cap. Pre-drilled holes for permanent installation.
$39.29
- Type: Speed Bump End Cap
- Length: 9"
- Width: 12"
- Height: 2-1/4"
- Construction: Made of 100% recycled rubber
- Misc.: Enhances appearance of the speed bump and helps prevent pedestrian trip and falls. Bottom of speed bump has channels to facilitate drainage from traffic surfaces, and may also be used to cover pipes and cables.
- Weight: 6.0 lbs. ea.
Combine Your Purchase With
Click on the thumbnails to see a larger image below.
 |
Full speed bump shown in reflective cat eyes and end caps attached
Installation Instructions
Installation of Park-It and Easy Rider with spikes (recommended for asphalt surfaces)
Drill 1/2" diameter holes in the asphalt through the product's holes Drive 1/2" rebar spike (14" long) through the holes in the productInstallation of Park-It and Easy Rider with lag bolts and metal shields (recommended for cement surfaces)
Use 1/2" or 5/8 lag bolts (6" long for Park-It, 5.5" long for Easy Rider) Drill 1/2" dia. pilot holes through the product's installation holes Remove the product, re-drill the holes for the diameter and depth required by the metal shields Install the metal shields, re-position the product and bolt it with lag bolts- Spec Sheet (59KB, PDF, Opens in new window)
Lead Time: 4-6 days + transit time
Weight: 6.0 lbs. ea.
Get Shipping Estimate
Country:
Zip:
3-year manufacturer's warranty of bump & 1-year on tape
