SKU: FlowBed123x44
Manufacturer: Unex
Hangers are not necessary with wheel beds as they will fit into any 1 5/8" rack beam scenario. The rear of the bed has an adjusting member to make the correct fit. The general application is to fill up any even width level of pallet rack using a combination of 18" and 12" tracks to make it full. i.e.: 96" wide bay beams would = Four 18" wide and Two 12" wide tracks.
Ideal for applications where:
This is the most critical dimension involved in specifying Flow Bed Span Track to fit into pallet rack. To determine the track length you need to measure between the beams from the innermost of each beam. The Between Beam Dimension represents the level, horizontal distance between the front and rear beams. Measure the level distance between the innermost part of each beam. If more than one length will fit, you should select the length that provides the most range for your application. You will need to set the discharge elevation later, based on the weight of your cartons. Unsupported spans of up to 10' are possible at 25 lbs. per square foot. If you have further questions about this dimension or other configuration issues, please contact Customer Service.