Constructed of an advanced retro-reflective material with microprisms, each dock reflector is backed by heavy-duty 14 gauge galvanized steel shaped in a convex curve top to bottom for reflectivity approaching a 90 degree angle. Each corner has a 5/16" mounting hole for solid mounting. The reflective material has a brilliance of up to 900 candle power and remains visible even at dock approach distances. Exceeding clause 7.5 of the industry standard EN471, this reflector has superior weather resistance to cold, heat, and wet conditions. Unit requires no light bulbs or electricity. Follow mounting instructions. Color: Red and White.
When ordering, consider alternating colors if purchasing for several loading docks. Doing this will further aid drivers when they can see that the dock they are pulling into has yellow reflectors, whereas the docks on each side are marked with red or red/white reflectors.
Mounting instructions
Utilize a wall anchoring tool to "shoot" anchors into dock sidewall using holes in corners of reflector as anchor points.
Lacking a concrete anchor tool, use 1" plastic screw anchors with screws, drill with 1/4" drill bit, scribe, ruler, level, and screw driver.
The reflectors should be vertically mounted approximately 2" below the rubber bumpers, but should be adjusted to avoid contact with the drive.
Drill one of the top holes first and mount in place. Leave this screw loose so as to allow vertical and plumb adjustments prior to tightening. Drill the remaining holes, then tighten all screws.