SKU: 25SRC-15-90S
Manufacturer: Hytrol
This gravity roller conveyor is used to carry heavy packages down a line in warehousing activities, shipping departments, assembly areas, etc. Most products will convey with minimum amount of pitch, obtained by adjusting the height of the floor supports (sold separately). The more the pitch is increased, the faster products will move down the line; so if very heavy products are being conveyed, steps should be taken to slow them down before they reach a stopping point. Gravity roller curves add to the versatility of straight conveyors and provide smooth product flow through turns.
Lead times have been temporarily extended and will be confirmed at time of order.
Conveyor width is measured in two ways; overall width (OAW) and between rail width. Overall width includes the width of the frame, which is 1-5/8" on either side of the rails. This means that the overall width would be 3-1/4" greater than the between rail width of the conveyor. Keep this in mind when determining what width of conveyor you need to meet your package requirements.
Conveyor curve length is determined by OAW. In general, the wider the piece of conveyor is, the more length it requires to turn a corner. Curved sections should be ordered with 2 floor supports for the ends and a single center leg support for the outside edge of the curve. The outside floor support will keep the curved conveyor from twisting and straining under the force of packages moving down the line. Floor supports also have an impact on overall capacity of the conveyor.
Each section of conveyor has butt couplings on both ends. These ends can be bolted together between conveyor sections to create long conveyor lines. Joined sections must have support installed beneath the couplings.
Example: If you are joining a 10 foot section and a 90 degree curve section, the minimum number of supports you would need is 3 supports plus 1 single center leg support; one support under the far end of each section, one support beneath the connection, and the center leg support for the outside edge of the curve. This configuration however would give your 10 foot section a lower capacity than the curved section unless you placed an intermediate support under the 10 foot.
More on Gravity Conveyors (Product sizes, spacing, capacities, etc.)
Lead Time: Temporarily extended; at time of order we will confirm lead time + transit time
Contact Cisco-Eagle to get a Shipping Rate for this item