AGVs (automated guided vehicles) move in-process parts across a mixed-use aisle on this production floor. Pedestrians, forklifts, and other workers share that same aisle, and anyone drifting into the AGV’s path stops it — creating delays and unnecessary safety risk.
We engineered a custom AisleCop® safety solution using gates, overhead sensors, guardrail, and floor markings, integrated directly with the facility’s AGV control system. Guardrail and floor markings separate the aisle from the surrounding production areas, and the gates rest in a position that keeps normal traffic moving.
This is a machine-activated configuration. The AGV initiates the crossing sequence rather than a person, which suits an aisle where automated traffic crosses on a schedule the floor cannot anticipate. AisleCop® systems can also be configured for pedestrian or forklift activation.
When an AGV needs to cross, it signals the AisleCop® system. Overhead sensors scan for cross traffic and the gates lower once the intersection is clear, while flashing warning lights alert forklift operators and nearby workers that the system has been engaged. The gates separating the aisle from the production areas lift fully before the system signals the crossing AGV to proceed. AisleCop® also signals other AGVs that the aisle gates are in position.
When the crossing AGV reports that it has cleared the area and overhead sensors confirm the intersection is empty, the gates reset and normal traffic resumes.
This system may utilize a combination of the following components to help manage a dangerous intersection or aisle.
These gate systems come with push-buttons as the standard activation method, with bright flashing red LED lights on the top of the arm for further visibility. They swing easily open and will stop when they meet an obstacle. They synchronize with motion sensors and any forklift gates utilized with the system.
Forklift gates raise and lower as triggered by various processes - the activation of a pedestrian gate, controls via motion detection, pull switches, ground loops, or other methods as needed per application.
Steel guard rails are not necessarily part of every forklift safety system, but are frequently used as part of the system to help manage and separate foot and vehicle traffic. Guard rails can be specified from ultra-heavy-duty to simple hand rails, to fit the needs of a particular application.
The typical AisleCop® system utilizes motion sensors to detect foot and vehicle traffic. These sensors can be mounted on either the forklift, on pedestrian gates, on walls, on racks, on guard rails, or at other spots as needed to monitor the protected zone.
AisleAlert™ adds a visual warning layer where gates aren't practical. Ceiling-mounted sensors scan the intersection and trigger a bright LED light that flashes directly down onto the floor at the center of the crossing, where both drivers and pedestrians will see it. The system triggers only when traffic converges from at least two directions, so it stays dark until there's an actual collision risk. Available in 2-way, 3-way, and 4-way configurations with a red or blue light.
AisleCop® systems are safety tools that are designed to help define and control access to forklift aisles. They do not provide 100% protection from industrial traffic accidents, and they are not a substitute for comprehensive workplace safety programs or procedures. AisleCop® gates direct and manage traffic flow but are not impact-resistant barriers and will not stop forklifts or other industrial vehicles.
The effectiveness of any AisleCop® system depends in part on factors outside the control of Cisco-Eagle, including but not limited to other critical factors, such as system and equipment maintenance, driver compliance, and pedestrian and individual compliance, enforcement of crossing lanes, and accurate assessment of safe crossings conditions. Users are solely responsible for these and all other safety measures.
Use of an AisleCop® system is at the user’s own risk. Users must follow all safety instructions, warnings, and applicable laws. AisleCop® systems are intended for professional environments and should be operated only by trained and qualified personnel. No representation is made or implied that the system can prevent all accidents, injuries, or losses.