Width
Belt conveyor width is measured in two ways; overall width (or bed width) and belt width. Overall width includes the width of the frame, which is 1.5" on either side of the belt. This means that the belt width would be 3" less than the overall width of the conveyor. Keep this in mind when determining what width of conveyor you need to meet your package requirements.
Length & Supports
Conveyor is available in 7 foot and 12 foot lengths for straight sections. The length of the conveyor along with the number of supports underneath greatly determine its load capacity. In most applications, supports should be placed in either 5 or 10 feet intervals depending on the weight of the product you are conveying. By installing a support every 5 feet, capacity of that section increases greatly.
Shipping
Conveyor is crated and shipped in 7ft and 12ft sections, depending on the overall length of the conveyor, and will need to be bolted together on-site. The drive assembly, reducer, and motor will shipped attached to one of these sections. Because these sections are unattached for shipping, the conveyor belt itself will also have to be attached onsite. Please note that this conveyor DOES NOT include electrical components or switches.
-
Lead Time: 2 week; some options may affect lead time; at time of order we will confirm lead time + transit time
- Belt Width: 12"
- Overall Width: 18"
- Bed Length: 45'
- Overall Length: 47'
- Belt: Ultimate 140 BBS–Nitrile
- Bed: 12 ga. galvanized slider pan mounted in 6-1/2" x 12 ga. powder painted formed steel channel frame bolted together with splice plates
- Center Drive: Provides 16" of belt take-up. Minimum elevation 17-3/4". Chain guard located on left hand side
- Drive Pulley: 8 in. dia. with 1-7/16 in. dia. shaft at bearings, fully lagged
- Tail Pulley: 4 in. dia. with 1 in. dia. shaft at bearings, machine crowned
- Snub Idler: Adjustable 2-1/8 in. dia. Pre-lubricated ball bearings. Guards included
- Return Idler: Adjustable 1.9 in. dia. pre-lubricated ball bearings
- Take-Up: Center drive provides 16" of belt take-up
- Bearings: Sealed, pre-lubricated, self-aligning, ball bearings on drive and tail pulleys
- Speed Reduction: Sealed worm gear C-Face speed reducer. No. 50 roller chain to drive pulley
- Motor: 1 HP–208/230/460V/575–3 Ph.–60 Hz. Energy Efficient C-Face
- Speed: Constant 65 feet per minute
- Supports: MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor
- Weight: 1514.6 lbs. ea.